Perkins 4.108 Peças do motor

High quality aftermarket Perkins 4.108 raw water pump mounting gaskets, to fit a 'Jabsco' raw water Pump Kit contains: x1 Pump to mounting plate...

A genuine Bowman Filler neck assembly for a Bowman type heat exchanger as fitted on later versions of the Perkins 4.108 engine. Bowman Part No. 392...

MPM propeller shaft grease is specially developed for marine applications. The grease has a very high resistance to water washout and is therefore ...

A Mono Ethylene Glycol (MEG) based engine coolant and anti-freeze concentrate from Comma. Gives up to 2 years protection against freezing and overh...

Standard aftermarket ethylene glycol concentrate (antifreeze) from MPM, can be used throughout the whole year in the cooling systems of petrol and ...

A set of five quality aftermarket raw water pump cover plate gaskets. Outside diameter 76mm Equivalent to Pekins part number 0490785 Equi...

Lloyds Approved Nautilus Marine Exhaust Hose. This is a strong but flexible rubber hose manufactured from synthetic textile fabrics and reinforced ...

Quality aftermarket adapter sleeve for the glow plug on marine versions of the Perkins 4.108. These heat resistant plastic adapters are designed to...

Quality aftermarket Perkins 4.108 12v heater plug (thermostart). It can be supplied with either the 'spade' or alternative 'screw' type electrical ...

Replacement 12 Volt, 16 ohm stop solenoid that fits the later versions of Perkins 4.108 fitted with electrically operated stop solenoid that screws...

Good quality aftermarket water temperature sender that fits the majority of early Perkins 4.107 engines.     Details: Spade type electrical connec...

Coolant drain tap for this Perkins 4.108 engine. This is a quality aftermarket part and is fully machined from solid brass. Equivalent to Perkins 3...

A pair of Stainless Steel T-bolt clamps with a fixed bridge, ideal for securing an exhaust hose to the heat exchange outlet on marine engines. Prod...

JB Marine Weld is a specially formulated two-part steel reinforced epoxy cold weld system that provides for strong, lasting repairs for bonding dif...

Perkins 4.108 Raw water pump alignment tool, used to centre the adaptor plate to ensure reduced wear on the drive shaft components as specified in ...

Quality aftermarket Perkins 4.108 Raw Water Pump Hose Tails (pair) to fit hose diameter 26 mm. UK, European and Worldwide delivery available.

Aftermarket alternator wiring connector kit, commonly known as a 'euro connector'. Fits many standard 3 pin alternators. UK, European and Worldwid...

Top quality aftermarket alternator and water pump belt which are the correct fitment for standard engines Perkins 4.108 engines. These standard bel...

Quality aftermarket 12 volt 65+ amp, 'high output' alternators fit all versions (including marine) of Perkins 4.108 engines set up for a 'three lug...

Quality aftermarket 14 Volt 70 Amp Insulated return alternator 'three lug' mounted alternator. The adjuster arm securing bolt is at a 120 degree an...

Quality aftermarket Perkins 4.108 alternator 12V fits all versions (including marine) of these engines set up for a 'three lug' mounted alternator....

High quality aftermarket This 12 volt Perkins alternator fits the Perkins 4.108 'lowline' marine engine. The adjuster arm securing bolt is at a 180...

High quality aftermarket 12 volt 90 amp high output alternators fit all versions Perkins 4.108 (including marine) of these engines set up for a 'th...

Aftermarket starter/ignition switch for Perkins 4.108 engines, including marine versions. We offer two switch options, which have either 4 pin or 6...