Perkins 4.248 Engine Parts

High quality aftermarket Perkins 4.248 Oil Filler cap. There are two sizes of oil filler cap used on Perkins 4.248. The larger 62 mm cap fits facto...

Exopro classic engine Mineral oil SAE 20W-50. An oil suitable for both petrol and diesel engines. Details: High zinc content for ultimate protecti...

UNF A2 Stainless steel nuts: UNF (Unified National Fine) 1/4 = 7/16 AF spanner size 5/16 = 1/2 AF spanner size Full Nut UK, European and Worldwi...

High quality aftermarket fuel banjo bolt set, includes: x4 Banjo bolts UK, European and Worldwide shipping available.

Aftermarket Injector leak-off rail that fits all versions of the Perkins 4.248. It has threaded outlets at both ends and is quality anodized produc...

High quality zinc plated aftermarket Perkins 4.248 injector pipes for mechanically governed pump only. These pipes will fit all types of 4.248 engi...

A high quality aftermarket pre-filter / water separator for Perkins 4.248 with re-usable internal gauze strainer and glass bowl. This universal sed...

A genuine Perkins Prima Series Fuel Filter - OE Part No. 26561117  Spin on type fuel filter, includes drain tap (height, 154mm, diameter 84mm). Wat...

Aftermarket fuel washers and seal kit for Perkins 4.248 Series. UK, European and Worldwide shipping available.

Replacement Perkins fuel filter assembly for Perkins 4.248 engines. This genuine Delphi quality part has the correct 1/2" UNF thread original fitti...

Quality aftermarket Perkins 4.248 fuel Lift Pump kit . We stock two and four bolt types for early and late engine versions. Kit includes gasket, p...

A set of aftermarket gaskets and seals to overhaul your Perkins 4.248 CAV DPA fuel pump. We stock both options for either the mechanically or hydr...

Aftermarket Perkins 4.248 Thermostat 70 mm (early version) with jiggle pin. Equivalent to Perkins 2485613 To fit engine codes: LF - 4.248 LG - ...

Strong, good quality Stainless Steel (304 grade) worm drive clamps ideal for both the marine environment and industrial use. Band width 12.5mm ...

Aftermarket Delphi blanking plug kit for Filter Assembly includes: x2 Blanking plugs (1/2"UNF thread) x2 Blanking plug copper washers x1 Air v...

This aftermarket water pump fits the majority of versions of the Perkins 4.248 including all marinized versions, OE equivalent No. U5MW0104. It com...

Aftermarket Low oil pressure alarm for Perkins 4.248 is a quality bulkhead mounted warning alarm, to be used in conjunction with an oil pressure sw...

Quality aftermarket 12 Volt, 150 Amp starter solenoid. This solenoid is for use with an Inertia type of starter motor. It requires a direct earth c...

Quality aftermarket replacement 12 Volt, 16 ohm stop solenoid that fits the later versions of Perkins 4.248 fitted with electrically operated stop ...

These 12 volt 65+ amp alternators fit all versions (including marine) of Perkins 4.248 engines set up for a 'three lug' mounted alternator. The adj...

High quality aftermarket Perkins 4.248 alternators 12V to fit all versions of these engines set up for a 'three lug' mounted alternator. The adjust...

Aftermarket Perkins 4.248 series Thermostat - equivalent to Perkins Part No. 2485613 Fits engines with codes beginning: LF - 4.248 LG - 4.2482 82°...

Aftermarket water temperature sender that fits early Perkins 4.248 engines. Spade type electrical connection for 12v or 24v systems Supplied with ...

A Mono Ethylene Glycol (MEG) based engine coolant and anti-freeze concentrate from Comma. Gives up to 2 years protection against freezing and overh...